Monitor GDS Data
1.

Connect GDS to DLC(Data Link Cable).

2.

Warm up the engine to normal operating temperature.

3.

Monitor "injector" parameter on GDS.

Fig 1) Normal data of Injector at idle.

4.

Are the parameters displayed correctly ?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was

repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor

connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as

necessary and go to "Verification of vehicle Repair" procedure.

▶ Go to "Terminal and Connector inspection" procedure

Яндекс.Метрика