Component Inspection
■ Check OCV resistance
1.

IG "OFF" and disconnect OCV connector.

2.

Measure resistance between power and signal terminals of OCV. (Component Side)

Specification : 6.7 ~ 7.7 Ω

3.

Is the measured resistance within specification?

▶ Go to "OCV Actuation Test" as follows.

▶ Substitute with a known - good OCV and check for proper operation.

If the problem is corrected, replace OCV and go to "Verification of Vehicle Repair" procedure.

■ OCV Actuation Test
4.

Connect GDS and IG "ON"

5.

Select "OIL CONTROL VALVE" on the Actuation Test

6.

Activates "OIL CONTROL VALVE" by pressing "START" button (should hear a faint click from Oil Control solenoid Valve)

7.

Repeat this procedure 4 or 5 times to ensure oil control solenoid valve reliability

8.

Does OCV generate click sound during acutation test ?

▶ Substitute with a known - good ECM and check for proper operation.

If the problem is corrected, replace ECM and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good OCV and check for proper operation.

If the problem is corrected, replace OCV and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика