6726769

1.

Ignition "ON" & Engine "OFF".

2.

Connect scantool and check DTC.

3.

Erase the DTC with scantool.

4.

After turning IG OFF to IG ON twice or three times, check DTC again.

5.

Does the scantool show same DTC again ?

	▶ Refer to the "Engine DTC guide".
	▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.