Monitor Scantool Data
1.

Connect scantool to data link connector(DLC).

2.

Engine "ON" .

3.

Monitor the "TRANSAXLE FLUID TEMPERATURE SENSOR "1" parameter on the scantool .

Specification : Increasing Gradually

Fig 1) Normal Data

4.

Does "TRANSMISSION FLUID TEMPERATURE SENSOR " follow the reference data?

▶ Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "verification of vehicle repair" procedure.

▶ Go to "W/Harness Inspection" procedure.

Яндекс.Метрика