Component Inspection
1.

IG "OFF" & Engine "OFF"

2.

Disconnect ATM control Unit(CLG01-C & CLG01-A) connector.

3.

Measure resistance between signal and ground terminal of range switch connector. (Component Side)

Specification : Refer to below table

Normal Condition(Any other conditions are treated as failure)

PIN No(C106-3)

GND

TransmissionRange Switch1(S1)

TransmissionRange Switch1(S2)

TransmissionRange Switch1(S3)

TransmissionRange Switch1(S4)

IND

P-R(Middle)

●

●

-

R

●

●

●

●

R

N-R(Middle)

●

●

●

●

-

N-D(Middle)

●

●

●

●

-

D

●

●

●

●

R

●： SWITCH IS ON(GND LEVER)

－： RANGE INDICATER LAMP "OFF" AND MAINTAIN PREVIOUS RANGE

4.

Is the measured resistance within specifications ?

▶ Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Check for open or short in harness. Repair as necessary and Go to "verification of vehicle repair" procedure.

▶ If signal circuit in harness is OK, Substitute with a known-good "TRANSMISSION RANGE SWITCH" and check for proper operation. If the problem is corrected, replace "TRANSMISSION RANGE SWITCH" as necessary and go to "verification of vehicle repair" procedure.

Яндекс.Метрика