Component Inspection
1.

Ignition "OFF".

2.

Connect "Sports mode s/w" connector.

3.

Ignition "ON" & Engine "OFF'.

4.

Measure the voltage between wiring side of "Sport mode select s/w, Sport mode up s/w, Sport mode down s/w" and chassis ground.

5.

Confirm voltage change when select "+, -" .

Specification : 12V(Before select) -> 0V(After select)

6.

Is "Measured voltage" within specification ?

▶ Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "verification of vehicle repair" procedure.

▶ Check for open or short in harness. Repair as necessary "Inhibitor switch" and Go to "Verification Vehicle Repair" procedure

Яндекс.Метрика