Connect GDS to Data Link Connector(DLC).

Engine "ON".

Select "Oil Level-Raw Value" ,"Oil Temperature" ,"Oil Level-Filtered Value" "Oil Level-Last Averaged Value"

"Oil Status" parameters on the GDS.

Are parameters displayed within available range?

	▶ Goto the "Component Inspection Procedure"
	▶ Check Engine oil level and Adjust Engine oil level properly.and then go to the "Component Inspection Procedure"

※ After performing ECM upgrade, Be sure that there is NO need to erase DTC"P250F" because DTC would erased automatically after approximately 50km traveling.(If there is NO problem in the system.)

※Be sure to replace the engine oil at KEY'OFF'. (If you replace the engine oil a key'ON', DTC"P250F" would be displayed.)

※ To reset the warning light(After adding engine oil),

- Cycle the ignition from "OFF" to "ON" 3times within 10 seconds, the warning light go off immediately.

- Travel approximately 50km after adding the engine oil, the warning light will go off.