3.
Has a problem been found?
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to 'Signal Circuit Inspection' procedure. |
Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to 'Signal Circuit Inspection' procedure. |
IG "ON" & ENG "OFF"
With controlling mirror with mirror switch of power window main switch, check voltage change(Input signal change) of terminal of vertical sensor.
Specification : It is as same as the signal waveform and data
Is the measured signal waveform within specification ?
| ▶ Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Check open or short in circuit of Mirror Vertical(UP/DOWN) Sensor. If the circuit of Mirror Vertical(UP/DOWN) Sensor is normal, replace the driver side mirror and go to "Verification of Vehicle Repair" procedure. |
