5.
Disconnect APS connector and measure resistance between APS terminals 1 and 6 (APS 2).
Specification: Refer to Specification Section.
Connect a scantool on the Data Link Connector (DLC).
Turn the ignition switch ON.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer to Specification Section.
Connect a scan tool to the Diagnoisis Link Connector (DLC).
Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.
Accelerator Position | Output Voltage (V) | |
APS1 | APS2 | |
C.T | 0.7 ~ 0.8V | 0.29 ~ 0.46V |
W.O.T | 3.85 ~ 4.35V | 1.93 ~ 2.18V |
Turn ignition switch OFF and disconnect the scantool from the DLC.
Disconnect APS connector and measure resistance between APS terminals 4 and 5 (APS 1).
Specification: Refer to Specification Section.
Disconnect APS connector and measure resistance between APS terminals 1 and 6 (APS 2).
Specification: Refer to Specification Section.
