1.
Disconnect the negative terminal from the battery.
Disconnect the negative terminal from the battery.
Remove the engine cover (A).
Remove the air duct (A) and the air cleaner assembly (B).
Disconnect the fuel hose (A) and the purge control solenoid valve (PCSV) hose (B).
Disconnect the ETC module connector (A).
Disconnect the PCSV connector (A) and the injector connectors (B).
Disconnect the variable intake system solenoid valve connector (A) and the wiring harness protector (B).
Disconnect the injector connectors (A).
Disconnect the PCV hose (A), the PCSV hose (B) and the water hoses (C) from the intake manifold module and the throttle body.
Remove the intake manifold module (A).
Installation the intake manifold module (A), tighten the nuts as following method.
Tightening torque :
1st step :
4.9 ~ 7.8N.m ( 0.5 ~ 0.8kgf.m, 3.6 ~ 5.8lb-ft)
2nd step :
19.6 ~ 26.5N.m ( 2.0 ~ 2.7kgf.m, 14.5 ~ 19.5lb-ft)
Reconnect the PCV hose (A), the PCSV hose (B) and the water hoses (C) to the intake manifold module and the throttle body.
Reconnect the injector connectors (A).
Reconnect the variable intake system solenoid valve connector (A) and the wiring harness protector (B).
Reconnect the PCSV connector (A) and the injector connectors (B).
Reconnect the ETC module connector (A).
Reconnect the fuel hose (A) and the purge control solenoid valve (PCSV) hose (B).
Install the air duct (A) and the air cleaner assembly (B).
Install the engine cover (A).
Reconnect the negative terminal to the battery.
