Be sure there is no play in the fuse holders, and that the fuses are held securely.

Are the fuse capacities for each circuit correct?

Are there any blown fuses?

If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.

Be sure that the relay (A) are held the each module securely.

Are the relay types for each circuit correct?

If system of some relay is not operate accurately, replace with a new one and check the system.

Disconnect the nagative(-) battery Terminal.

Remove the rear left luggage side trim.

(Refer the body group - "Interior trim")

Remove the woofer after disconnecting the connector (A) and loosening the mounting nuts (4EA).

Remove the RAM (A) after disconnecting the connectors (4EA) and loosening the mounting bolts (3EA).

Disconnect the back side connector (A) of RAM.

Installation is the reverse of removal procedures.

Disconnect the negative (-) battery terminal.

Remove the crash pad lower panel (A). (Refer to the Body group - Crash pad).

Disconnect the IPM connectors (A) and the receiver antenna cable.

Remove IPM mounting nuts (3EA) and IPM (A).

Disconnect the back side connector of IPM.

Installation is the reverse of removal procedures.