2.
Remove the baffle plate (A).
Remove the timing chain and chain case assembly (Refer to Timing system in this group)
Remove the baffle plate (A).
Compress the tensioner arrow direction for insert the stopper pin (A) into the tensioner hole, and then remove the oil pump chain tensioner (B).
Remove the oil pump chain (A) and crankshaft sprocket (B).
Remove the oil pump assembly (A).
Before installing the oil pump and screen assembly on the bed plate, check if the O-ring is seated properly and not damaged.
Install the oil pump and screen assembly with the specified torque.
Tightening torque :
19.6 ~ 26.5N.m (2.0 ~ 2.7kgf.m, 14.5 ~ 19.5lb-ft)
Check if the oil pump works properly.
With the cylinder block, bed plate, crankshaft piston assembly, connecting rod assembly and the oil pump assembly installed, insert the crankshaft sprocket (B) in the crankshaft, aligning the No.1 piston at the BDC (Bottom Dead Center).
Install the oil pump chain (A).
Install the oil pump chain tensioner (B) and remove the stopper pin (A) from the tensioner.
Tightening torque :
7.8 ~ 11.8N.m ( 0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)
Install the baffle plate (A).
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
Install the timing chain case and timing chain. (Refer to Timing system in this group)
