4.
Driving above 20 Km/h.
Specification : Increasing Gradually
Fig 1) Low speed
Fig 2) High speed
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & Engine "ON".
Selet "Currnet Data"mode and monitor "Output speed sensor" parameter.
Driving above 20 Km/h.
Specification : Increasing Gradually
Fig 1) Low speed
Fig 2) High speed
Is measured "Output speed sensor" value within specification?
 | ▶ Fault is intermittent caused by poor contact between TCM and Sensor, and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "Terminal and Connector Inspection" procedure. |
