4.
Disconnect the negative terminal from the battery.
Use fender covers to avoid damaging painted surfaces.
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Mark all wiring and hoses to avoid misconnection.
First, remove the transmission before removing the engine. (Refer to AT group)
Remove the bonnet. (Refer to BD group)
Remove the cowl cover and wiper arm. (Refer to BE group)
Disconnect the negative terminal from the battery.
Remove the engine cover (A).
Remove the radiator grill upper guard (A).
Loosen the drain plug (A) and drain the engine coolant.
Remove the radiator cap (A) to speed draining.
Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the radiator.
Recover refrigerant. (Refer to Air conditioner compressor in HA Group)
Remove the air duct (A) and the air cleaner assembly (B).
Disconnect the radiator upper hose (A) and lower hose (B).
Remove the radiator upper shroud (A).
Remove the cooling fan (A).
Remove the cooling fan clutch (A).
Remove the cooling fan clutch (A) after fixing the cooling fan pulley (B) by inserting a pin (C) into the hole of it.
Disconnect the heater hoses (A), the fuel hose (B) and the purge control solenoid valve (PCSV) hose (C).
Remove the engine wire harness from the fuse and relay block.
Remove the ECM connector (B) and the fuse and relay block cover (A).
Remove the connectors (A) and the cable (B) from the fuse and relay block (C).
Remove the fuse and relay block (C).
Remove the fuse and relay block connector (A) and the multi connector (B).
Remove the fuse and relay block lower cover (A).
Remove the connector (A) from the fuse and relay block lower cover bracket.
Remove the earth cable (A) and the harness protector (B).
Remove the power steering pump pressure switch connector (A).
Remove the cable (A) from the battery.
Remove the air conditioner high pressure pipe (A). (Refer to HA group)
Remove the oxygen sensor connector (A).
Remove the exhaust manifold heat protector (A).
Remove the exhaust manifold (A).
Remove the engine mounting bracket nuts (A) and the earth cable (B).
Tightening torque :
49.0 ~ 63.7Nm (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)
Remove the engine assembly from the vehicle by using hoist.
When removing the engine assembly, be careful not to damage any surrounding parts or body components.
