3.
Draw the front tunnel pad (B) back after disconnectiong fixing clip(A) for wiring harness.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the floor console. (Refer to Body group-Console)
Draw the front tunnel pad (B) back after disconnectiong fixing clip(A) for wiring harness.
Remove the Longitudinal G sensor mounting nuts (A).
Tightening torque:
4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.1 Ib-ft)
Disconnect the Longitudinal G sensor connector (B).
Installation is the reverse of removal.
If you replace Longitudinal G sensor, Steering Wheel Angle Sensor (SAS) should be performed calibration. (Refer to Steering Wheel Angle Sensor in BR group.)
