1.
Loosen the checker (A) mounting bolts.
Loosen the checker (A) mounting bolts.
Detach the clips, remove the weatherstrip (A).
Installation is the reverse of removal.
After loosening the mounting bolt, remove the lock cylinder (A).
Remove the outside handle (A) by sliding it rearward.
Disconnect the connector (A).
Installation is the reverse of removal.
Make sure door lock operates and door open/closes properly.
Be careful not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the quadrant inner cover (A).
Remove the inside handle cover (A).
Loosen the door trim (A) mounting screws.
Release the clips that hold the door trim.
Remove the inside handle cage (A).
Disconnect the connectors (A).
Installation is the reverse of removal.
Make sure connectors are connected properly and each rod is connected securely.
Make sure door lock operates and door open/closes properly.
Remove the door trim.
Loosen the mounting screw, remove the inside handle (A).
Installation is the reverse of removal.
Remove the front door trim.
Remove the glass mounting hole plug (A).
Using the door switch to align the mounting hole with the hole on the door glass.
If it is impossible, align the hole by hand after removing the motor.
Be careful not to drop to glass and scratch the glass surface.
Carefully adjust the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Tightening torque :
8.8~11.8 N.m (0.9~1.2 kgf.m, 6.5~8.7 lb-ft)
Installation is the reverse of removal.
Roll the glass up and down to see if it move freely without binding.
Adjust glass position as needed.
Remove the door trim.
Drill out the rivets to remove the speaker (B) from the door module.
Disconnect the speaker connector (A).
Installation is the reverse of removal.
Use sheet metal screws to secure the speaker.
Remove the door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
Grease should be applied to areas where there is of rotational parts and springs.
Roll the glass up and down to see if it move freely without binding.
Remove the following parts.
Door trim
Window glass
Outside handle
Loosen the mounting screw (A).
Loosen the door module mounting bolts, remove the door module (A).
Disconnect the connector (A).
Disconnect the door module wiring harness (B), remove the module assembly.
Installation is the reverse of removal.
The area of whole parts should be applied with sufficient grease.
Make sure connected are connected properly and each rod is connected securely.
Make sure door lock operates and door open/closes properly.
Remove the following parts :
Door trim
Glass
Out side handle
Remove the module assembly.
Disconnect the inside handle cage (A), remove the latch assembly (B).
Installation is the reverse the removal.
Make sure door lock operates and door open/closes properly.
Remove the following parts :
Door trim
Window glass
Door module
After loosening the mounting bolts, remove the door checker (A).
Installation is the reverse of removal.
Make sure the door opens properly and locks securely.
