2.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Remove the seat assembly mounting cover.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Disconnect the connectors (A), and remove the seat assembly.
Remove the seat belt lower anchor cover (A).
After loosening the seat belt lower anchor mounting bolt, remove the seat assembly (A).
Disconnect the connector (A).
Installation is the reverse of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE (manual seat only)
Set the into the most rearward position. Check then each slide is locked, and then tighten the front mounting bolt temporarily.
Set the seat into most forward position. Check that each slide is locked, and then tighten the rear mounting bolt completely.
Set the seat into the most rearward position. Check the front mounting bolt completely.
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Remove the cover (A).
After loosening the mounting screws, remove the recliner cover (A).
Disconnect the connector (A).
Installation is the reverse of removal.
Remove the front cover (B).
After loosening the mounting screw, remove the recliner cover (A).
Installation is the reverse of removal.
Remove front seat assembly.
Remove the recliner cover.
Disconnect the connectors (A).
After disconnect the protector (A), remove the seat cushion (B).
After removing the hogring clip on the front of seat cushion and remove the seat cushion cover (A).
Installation is the reverse of removal.
Remove front seat assembly.
Remove the headrest.
Remove the lumber support level (A).
After disconnecting the scuff band, remove the seat back panel (A).
Disconnect the protector (A) from the back frame.
Disconnect the connector (A).
Pull out the headrest guides (A) while pinching the end of the guides, and remove them.
After removing the hogring clip on the front of seat back and remove the seat back cover (A).
Installation is the reverse of removal.
Remove the following items :
Recliner cover
Seat back panel
Headrest guide
Seat back cover
After loosening the mounting bolts, disconnect the seat back frame (A) and seat cushion frame (B).
Remove the side air bag for replacing side air bag installation seat.
Before service, be fully aware of precautions and service procedure relevant to air bag (Refer to page RT-Airbag)
Installation is the reverse of removal.
Remove the seat cushion cover.
Cut the heater (B) attached to the sponge (A), as shown in the picture.
Be careful not to damage the slave sponge.
Install the seat back cover.
Detach the paper from the back of the heater assembly.
Attach the heater to the main part of the sponge.
Be sure to match the heater with main appearance.
Remove the seat back cover.
Cut the heater (B) attached to the sponge (A), as shown in the picture.
Be careful not to damage the slave sponge.
Install the seat back cover.
Detach the paper from the back of the heater assembly.
Attach the heater to the main part of the sponge.
Be sure to match the heater with main appearance.
