13502123

caution

●

After replacing ECM, MUST input the injector specific data (7 digits) of each cylinder into a new ECM with the GDS.

●

In the case of the vehicle equipped with immobilizer or smart key, perform "KEY TEACHING" procedure together (Refer to "Immobilizer" or "Smart key system" in BE group).

caution

When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.

[In the case of installing used ECM]

1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)

2) After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to "Immobilizer" in BE group)

[In the case of installing new ECM]

Perform "Key teaching" procedure with GDS. (Refer to "Immobilizer" in BE group)

caution

When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.

[In the case of installing used ECM]

1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Smart key" in BE group)

2) After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.

[In the case of installing new ECM]

Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.

Install a new ECM.

ECM installation bolts (on bracket):

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Perform "ECM Change" procedure [With CPF].

(1)

Turn ignition switch OFF.

(2)

Connect the GDS to Data Link Connector (DLC).

(3)

Turn ignition switch ON.

(4)

Select "Vehicle, Model year, Engine, System".

(5)

Select "Vehicle S/W Management".

(6)

Select "Component Change Routine".

(7)

Select "ECU Change".

(8)

Input the mileage in odometer.

(9)

Confirm the "Complete" message and then turn ignition switch OFF.

(10)

Wait for more than 10 seconds, and then turn ignition switch ON.