2.
Connect the CKP sensor(A).
Temporarily install the tansmission assembly by lifting the supporting jack.
Be careful not to damage tubes, hoses or wire.
Connect the CKP sensor(A).
Install the mounting bolts (A-2ea, B-2ea) on the transmission side.
Tightening torque :
(A) 80~100 Nm (8.0~10.0 kgf.m, 57.8~72.3 Ib-ft)
(B) 63.7~83.4N.m(6.5~8.5kgf.m, 47.0~61.5 Ib-ft)
Install the mounting bolts (A-2ea) for the starter motor.
Tightening torque :
35~47 Nm (3.5~4.7 kgf.m, 25.3~33.9 Ib-ft)
Install the mounting bolts (A-2ea).
Tightening torque :
35~47 Nm (3.5~4.7 kgf.m, 25.3~33.9 Ib-ft)
Install the mounting bolts (A-4ea) lower in the engine side.
Tightening torque :
40~47 Nm (4.0~4.7 kgf.m, 28.9~33.9 Ib-ft)
Install the torque converter mounting bolts (A-6ea) by rotating the crank shaft.
Tightening torque :
46~53 Nm (4.6~5.3 kgf.m, 33.2~38.3 Ib-ft)
Install the dust cover(A).
Install the wire holding brackets on the transmission.
Install the oil cooler hose mounting bolt (A) and the bracket mounting bolt (B).
Connect the TCU connector(A).
Install the exhaust manifold stay (A).
Install the ground wire (A) by the bolt.
Install the mounting bolts(A,B-4ea) and the transfer assembly.
Tightening torque :
30~42 Nm (3.0~4.2 kgf.m, 21.6~30.3 Ib-ft)
Connect the 4WD ECU connector(A) or EMC connector(B).
Connect the shift cable assembly (A)
Install the cross member(A)
Install the insulator support bracket(A).
Tightening torque :
50~65 Nm (5.0~6.5 kgf.m, 36.1~47.0 Ib-ft)
Install the cross member (A) by installing the bolts(8ea).
Remove the exhaust manifold stay (A).
Install the muffler assembly. (refer to Muffler in EM group)
Put aside the transmission jack.
Install the rear propeller shaft. (refer to Propellar shaft in DS group)
Connect the battery (-) terminal.
Refill the automatic transaxle fluid. (refer to Inspection and Adjustment)
