2.
Remove the thermostat (C) with its gasket (B) after taking off the water inlet fitting (A) from the water temperature control assembly.
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency.
Drain the engine coolant so its level is below thermostat.
Remove the thermostat (C) with its gasket (B) after taking off the water inlet fitting (A) from the water temperature control assembly.
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
Installation is reverse order of removal.
Install the thermostat (C) with the jiggle valve upward.
Conform to what is described above because tension of the belt in this engine is higher than ones of other engines for preventing a slip.
