The SRSCM sets DTC B135200 if the measured resistance value of PAB circuit is more than the threshold value.
*In this case, SRSCM checks if there's any fault in circuit by sending current for a while
Item | Detecting Condition | Possible cause | |
DTC Strategy |
•
Check Resistance | 1. Poor connection of connected part. 2. Poor connection between shorting bar and release pin. 3. Faulty PAB. 4. Check SRSCM | |
Enable Conditions |
•
Ignition "ON" | ||
Threshold Value |
•
PAB 1st stage Squib resistance > 6.9Ω | ||
Diagnostic Time | Qualification |
•
More than 2s (200ms x 10) | |
De-Qualification |
•
More than 4s (200ms x 20) | ||
