Remove the valve core and deflate the tire.

Remove the side of the tire bead area from the wheel using tire changing machine .

Rotate the wheel clockwise.

The valve during transportation (air inlet portion of the silver) deviated from its original location be sure to check whether the original position of the valve (metal brackets) are assembled in indented state.

While tightening the nut on the valve as not to deviate from the fixed position while rotating the valve to a fixed location (metal brackets to fit inside) and push. The specified torque (8Nm) to tighten the nut does not reuse.

Contact with the rim so that the valve washer seals the valve hole put into.

Housing with two fingers holding the valve in the axial direction with one finger and push the valve.

Housing, the state must be visible laser marking.

When the valve is fully inserted so that the contact between the sensor and the rim while keeping hands on the wheel nut tightening will start Wed.

While maintaining the position of the valve and the sensor is mounted nut.

Apply tire soap or lubrication to the top and bottom tire beads.

To fit the bottom bead, position the sensor at the 5 o’clock position relative to the head on the tire changing machine

Place the tire on the rim so the bottom bead touches the edge of the rim after the sensor (@6 o’clock). Rotate the rim clockwise, and push down on the tire at the 3 o’clock position to fit bottom bead.

After bottom bead is on tire, rotate the rim until the sensor is at the 5 o’clock position relative to the head on the tire changing machine. Push down on the tire at the 3 o’clock position and rotate the rim clockwise to fit the top bead.

Inflate the tire until both beads seat.

In the case of TPMS sensor failure, TPMS sensor needs learning. Faulty sensor is replaced new units, conduct learning of TPMS sensors.