3.
Connector (A) After removing the new receiver (B), must be replaced.
When the receiver first arrives for replacement:
It will be in Virgin State.
It will not be configured for any specific platform.
It will not have any sensor ID's memorized.
It is important to make sure that the correct receiver is used to replace the faulty part i.e.
Disconnect the negative (-) battery cable.
Remove the main crash pad Assembly.
<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=bd&mmcid=4&group=SHOP&pdftype=&cat1=2013+%3E+G+1%2E6+MPI&ec=&firstnodedesc=Body+%28Interior+and+Exterior%29&sitinfolist=91%5E9154%5E91540150%5Enone%5E801%5E6%5EENG%5EKM%5EJD12%5E2013%5Ebd%5E4%5Enone%5Enone%5Enone%5ESHOP%5E%24"target="_blank">(Refer to Body (Interior and Exterior) - "Main Crash Pad Assembly")</a>
Connector (A) After removing the new receiver (B), must be replaced.
Install in the reverse order of removal.
Re-connect battery and turn Ignition on.
After replacing the receiver, learn by using self-diagnosis device(GDS).
