Turn the lamp switch off.
Disconnect the connector.
Remove the dust cap (A).
Remove the ignitor fixing clip (A).
Remove the ingnitor and HID bulb (A).
Installation is the reverse of removal.
Turn the lamp switch off.
Remove the dust cap (A).
Remove the connector (A) and fixing clip (B).
Remove the bulb (A).
Installation is the reverse of removal.
Turn the lamp switch off.
Remove the head lamp assembly.
Disconnect the power connector from the lamp.
Remove the ballast (A) after loosening the screws (4EA).
Disconnect the connector (A).
Be careful not to be damaged when disconnecting the ballast connector pin (A).
Installation is the reverse of removal.
Turn the head lamp switch off to avoid high voltage.
HID lamp shall not be used on other cars. (Fire may occur.)
Fire may occur when HID lamp initially lights due to the fact that arc-discharge generates high voltage (max. 20,000V) and high current (12-13A), and are different from the halogen lamp specification.
Install the dust cover after confirming the locking state between bulb and bulb holder.
When testing the HID head lamp, turn the power on or off with switch between power supply and lamp because of high voltage.
Do not operate the head lamp switch with the bulb not installed, because it generates spark momently.
Turn the lamp switch off.
Turn the bulb socket (A) counterclockwise and remove it from head lamp assembly.
Remove the bulb from socket.
Installation is the reverse of removal.