3.
Remove the rear part of the front side engine room under cover (A).
Remove the right side front tire.
Separate the front portion of the front wheel guard from the wheel house.
Remove the rear part of the front side engine room under cover (A).
Loosen the drive belt.
<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=en&mmcid=109&group=SHOP&pdftype=&cat1=2013+%3E+G+1%2E6+MPI&ec=&firstnodedesc=Engine+Mechanical+System&sitinfolist=12%5E1205%5E12051110%5Enone%5E801%5E1%5EENG%5EKM%5EJD12%5E2013%5Een%5E109%5Enone%5Enone%5Enone%5ESHOP%5E%2412%5E1205%5E12051110%5Enone%5E801%5E4%5EENG%5EKM%5EJD12%5E2013%5Een%5E109%5Enone%5Enone%5Enone%5ESHOP%5E%2412%5E1205%5E12051110%5Enone%5E801%5E5%5EENG%5EKM%5EJD12%5E2013%5Een%5E109%5Enone%5Enone%5Enone%5ESHOP%5E%2412%5E1205%5E12051110%5Enone%5E801%5E8%5EENG%5EKM%5EJD12%5E2013%5Een%5E109%5Enone%5Enone%5Enone%5ESHOP%5E%24"target="_blank">(Refer to Engine Mechanical - "Drive Belt")</a>
Remove the center bolt (A) and the hub bolts while holding the pulley with a disc ＆ hub assembly bolt remover (09977-3R000).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Loosen the mounting bolts and then remove the disc ＆ hub assembly (A).
Remove the pulley (B) after removing the snap ring (A) with snap ring pliers.
Be careful not to damage the pulley and compressor during disassembly/reassembly.
Once snap ring is removed, replace it with a new one.
Reassembly is the reverse order of disassembly.
Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
Install new snap ring, and make sure they are fully seated in the groove.
Make sure that the pulley turns smoothly after reassembly.
