Check ignition lock switch pull-up voltage
IG KEY "OFF", ENGINE "OFF".
Disconnect ignition lock switch connector.
IG KEY "ON".
Measure the voltage between signal terminal of ignition lock switch harness connector and chassis ground.
Specification : 11.5V ~ 13.0V
Check open in ignition lock switch signal circuit
IG KEY "OFF", ENGINE "OFF".
Disconnect ignition lock switch connector and ECM connector.
Check continuity between signal terminal of lock switch signal harness connector and ECM harness connector.
Specification : Continuity ( below 1.0Ω )
IG KEY "OFF", ENGINE "OFF".
Disconnect ignition lock switch connector.
Check continuity between lock switch signal connector terminal 1 and chassis ground.
Specification : Continuity ( below 1.0Ω )
Remove the ignition lock switch.
Push the ignition lock switch in the direction of the arrow to make sure that continuity between terminals. (refer to the table below)
Standard value :
Full stroke (A): 12.0 ± 0.3mm (0.4724 ± 0.0118 in.)
ON-OFF point (B): 2.0 mm(0.0787 in.)
Condition | Clutch Pedal pressed | Clutch Pedal Released |
Switch Operation | ON (below 1.0Ω ) | OFF ( Infinite Ω ) |
