13670042

caution

When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.

[In the case of installing used ECM]

Perform "Neutral mode" procedure with GDS.

<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=imm&mmcid=1&group=SHOP&pdftype=&cat1=2013+%3E+D+1%2E4+TCI%2DU2&ec=&firstnodedesc=Body+Electrical+System&sitinfolist=92%5E9274%5Enone%5Enone%5E801%5E4%5EENG%5EKM%5EJD12%5E2013%5Eimm%5E1%5Enone%5Enone%5Enone%5ESHOP%5E%2492%5E9274%5Enone%5Enone%5E801%5E5%5EENG%5EKM%5EJD12%5E2013%5Eimm%5E1%5Enone%5Enone%5Enone%5ESHOP%5E%2492%5E9274%5Enone%5Enone%5E801%5E6%5EENG%5EKM%5EJD12%5E2013%5Eimm%5E1%5Enone%5Enone%5Enone%5ESHOP%5E%24" target="_blank">(Refer to Body Electrical System - "Immobilizer System")</a>

Insert the key and turn it to the IGN ON and OFF position.

Then the ECM key register process is completed automatically.

[In the case of installing new ECM]

Insert the key and turn it to the IGN ON and OFF position.

Then the ECM key register process is completed automatically.

Install a new ECM.

ECM bracket installation bolt:

19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

ECM installation nut:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Perform "ECM Change" procedure [With DPF].

(1)

Turn ignition switch OFF.

(2)

Connect a GDS Data Link Connector (DLC).

(3)

Turn ignition switch ON.

(4)

Select "Vehicle, Model year, Engine, System".

(5)

Select "Vehicle S/W Management".

(6)

Select "Component Change Routine".

(7)

Select "ECU Change".

(8)

Input the mileage in odometer.

(9)

Confirm the "Complete" message and then turn ignition switch OFF.

(10)

Wait for more than 10 seconds, and then turn ignition switch ON.

Perform "Key Teaching" procedure.