2.
Then remove the head lamp washer nozzle cover (A) by widening both lock pins (B) outward using two gimlets.
Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Pull out the head lamp washer nozzle outward.
Then remove the head lamp washer nozzle cover (A) by widening both lock pins (B) outward using two gimlets.
Loosen the radiator upper cover (A) mounting clips.
Loosen the front bumper lower mounting clips.
After loosening the front bumper side's mounting screw, then disconnect the side's.
Disconnect the fog lamp connector (A) and front parking assist sensor connector (B).
[LH]
[RH]
Remove the front bumper cover (A).
Install in the reverse order of removal.
Replace any damaged clips.
Make sure the connector is plugged in properly.
