3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.
Turn ignition switch OFF.
Disconnect PCSV connector.
Measure resistance between PCSV terminals 1 and 2.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the purge control solenoid valve connector (A).
Disconnect the vapor hoses (B) from the purge control solenoid valve.
Remove the bracket installation nuts (A), and then remove the purge control solenoid valve.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Be careful of foreign material not to flow into the valve.
Installation is reverse of removal.
