1.
Install the jack to the edge of oil pan to support the engine.
note
Insert the rubber block between jack and oil pan.
Install the jack to the edge of oil pan to support the engine.
Insert the rubber block between jack and oil pan.
Remove the engine mounting support bracket (A).
Tightening torque
Nut (B):
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.5 lb-ft)
Bolt and nuts (C):
58.8 ~ 73.5 N.m (6.0 ~ 7.5 kgf.m, 43.3 ~ 54.2 lb-ft)
Remove the reservoir tank .
(Refer to Cooling System - "Reservoir tank")
Remove the engine mounting bracket (A).
Tightening torque :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
Install in the reverse order of removal.
Remove the roll rod bracket (A).
Tightening torque
Bolt (B) :
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
Bolt (C) :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
Remove the roll rod support bracket (A).
Tightening torque :
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.2 ~ 50.6 lb-ft)
Install in the reverse order of removal.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the engine room under cover.
(Refer to Engine and Transmission Assembly - "Engine Room Under Cover")
Install the jack to the edge of transaxle.
Remove the cover (A).
Remove the transaxle support mouting bracket bolt (A).
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.5 lb-ft)
Remove the transaxle mounting bracket (A).
Tightening torque :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
Install in the reverse order of removal.
