Remove the engine cover.
Disconnect the battery negative terminal.
Disconnect the engine wiring connector and haness clamp and disconnect the wiring from intake manifold.
Injector extention connector
MAPS (Map Sensor) connector
Knock Sensor connector
Front connector
CKPS(Crank Shaft Position Sensor) connector
vacuum pump extention connector
ETC(Electric Throttle Control) Module connector
PCSV(Purge Control Solenoid Valve) connector
Disconnect the PCV (Positive crankcase ventilation) hose (A) and the PCSV (Purge control solenoid valve) hose (B).
Remove the intercooler outlet hose (A).
Disconnect the vacuum hose (A) and the throttle body coolant hoses (B).
Unfasten the filler neck assembly mounting bolts (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Disconnect the vacuum hose (A).
Remove the intake manifold (A) with the gasket (B).
Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)
When installing, replace with new gaskets.
When installing the intake manifold, tighten the bolts and nuts with pre-torque first, and then tighten the bolts and nuts with specified torque in the sequence shown.
Install in the reverse order of removal.
