2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the mounting bolt.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the mounting bolt.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage.
Install in the reverse order of removal.
Crankshaft position sensor mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
