4.
Remove the panoramaroof motor (B) after loosening 3 bolts.
Disconnect the negative (-) battery terminal.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
Disconnect the connector (A).
Remove the panoramaroof motor (B) after loosening 3 bolts.
Ground the terminals as below table, and check that the panoramaroof unit operates.
When inspecting the panoramaroof motor operation, panoramaroof motor and roller blind motor always should be connected.
Make these input tests at the connector. If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the panoramaroof motor must be faulty; replace it.
Terminal | Test condition | Test: Desired result |
3 | IG2 ON | Check for voltage to ground: There should be battery voltage. |
1 | Under all conditions | Check for continuity to ground: There should be continuity. |
6 | Under all conditions | Check for voltage to ground: There should be battery voltage. |
