If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with ISG function, Battery sensor recalibration procedure should be performed after finishing the repair work.
Turn the Iginition switch ON and OFF.
Park the vehicle about 4 hours under below states.
Park the vehicle about 4 hours under below states.
Closing the hood, trunk, and all doors.
After 4 hours later, check whether the current datas are displayed normally or not using GDS.
Nominal capacity(AMS) = 60Ah
State of Charge of Battery(AMS) = (0~100%)
State of Health of Battery(AMS) = (0~100%)
After cranking the engine 2 times or more, check "State of Function of Battery(AMS) =(0~12V)".
If "ISG Inhibition Condition Due to Urgent Charging Battery Logic(Low SOC)" is ON in the current data as below, battery refresh logic release procedure should be performed.
There are 2 methods to release the battery refresh logic.
Method 1) Chrge the battery more than 95% SOC.
Method 2) Drive the vehicle until total driving time is more than 2 hours.
Perform one of two methods.
Check "ISG Inhibition Condition Due to Urgent Charging Battery Logic(Low SOC)" is OFF using GDS.
Remove the ISG switch from the switch assembly.
Check the continuity between the switch 3 and 6 terminals as the ISG OFF switch is engaged.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the crash pad lower panel.
<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=bd&mmcid=4&group=SHOP&pdftype=&cat1=2013+%3E+G+1%2E6+MPI&ec=&firstnodedesc=Body+%28Interior+and+Exterior%29&sitinfolist=91%5E9154%5E91540040%5Enone%5E801%5E6%5EENG%5EKM%5EJD12%5E2013%5Ebd%5E4%5Enone%5Enone%5Enone%5ESHOP%5E%24" target="_blank">(Refer to Body - "Crash Pad Lower Panel")</a>
Remove the crash pad low switch assembly (A) after loosening the screws.
Remove the ISG OFF switch.
Installation is reserve of removal.