3.
Disconnect the fuel feed tube (A) after remove the nuts (B).
Turn the ignition switch OFF, and then remove battery (-) cable.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Disconnect the fuel feed tube (A) after remove the nuts (B).
Disconnect the vapor hose (A) which is connected from the PCSV.
Disconnect the fuel pump connector (A) and fuel feed quick-connector (B) from the fuel pump.
Disconnect the vapor tube quick-connector (C).
Lift the vehicle.
Remove the fuel tank.
(Refer to Fuel Delivery System - "Fuel Tank")
Open the vapor tube and low fuel line fixing clip (A) to using driver.
Remove the installation nuts, and then push the heat protect in the direction.
Remove the installation bolt (A), and then remove the fuel line fixing clip (B).
Disconnect the fuel & brake line protect (A) from the fixing clip.
Remove the fuel line (A).
Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Installation is reverse of removal.
