5.
Disconnect the water sensor connector (A), the heater connector (B).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the air cleaner assembly.
<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=en&mmcid=348&group=SHOP&pdftype=&cat1=2013+%3E+D+1%2E6+TCI%2DU2&ec=&firstnodedesc=Engine+Mechanical+System&sitinfolist=12%5E1235%5E12350100%5Enone%5E801%5E1%5EENG%5EKM%5EJD12%5E2013%5Een%5E348%5Enone%5Enone%5Enone%5ESHOP%5E%24" target="_blank">(Refer to Engine Mechanical System - "Air Cleaner")</a>
Remove the battery.
<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=en&mmcid=348&group=SHOP&pdftype=&cat1=2013+%3E+D+1%2E6+TCI%2DU2&ec=&firstnodedesc=Engine+Electrical+System&sitinfolist=11%5E1125%5E11250200%5Enone%5E801%5E1%5EENG%5EKM%5EJD12%5E2013%5Een%5E348%5Enone%5Enone%5Enone%5ESHOP%5E%2411%5E1125%5E11250200%5Enone%5E801%5E4%5EENG%5EKM%5EJD12%5E2013%5Een%5E348%5Enone%5Enone%5Enone%5ESHOP%5E%2411%5E1125%5E11250200%5Enone%5E801%5E3%5EENG%5EKM%5EJD12%5E2013%5Een%5E348%5Enone%5Enone%5Enone%5ESHOP%5E%24" target="_blank">(Refer to Engine Electrical System - "Battery")</a>
Remove the ECM.
(Refer to Engine Control System - "ECM")
Disconnect the water sensor connector (A), the heater connector (B).
Disconnect the fuel inlet tube (A) quick-connector and the fuel outlet tube (B) quick-connector.
Unscrew the fuel filter installation nuts (A), and then remove the fuel filter assembly (B) from the vehicle.
Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Remove the water sensor (A).
Remove the fuel filter assembly from the bracket after removing the bracket nuts (C) and bolt (B), replace it with a new one, and then install the fuel filter assembly in accordance with reverse of above steps.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
1. Filter body
2. Fuel heater
3. Bracket
4. Fuel filter
5. Water sensor
When replacing the fuel filter, must replace the O-ring.
Bleed air in low pressure fuel circuit.
(Refer to Fuel Delivery System - "Bleeding Air in Low Pressure Fuel Circuit")
Start the engine and check that there is any leak on the low pressure fuel circuit including the fuel filter.
