3.
Disconnect the low pressure fuel quick-connector (A).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the fuel tank.
(Refer to Fuel Delivery System - "Fuel Tank")
Disconnect the low pressure fuel quick-connector (A).
Disconnect the low pressure fuel feed line quick-connector (A) from the fuel filter.
Lift the vehicle.
Remove the undercover (A) after removing installation nuts (B).
Place the front heat protector (A) in the direction of the arrow after removing the installation nuts (B).
Remove the fuel line fixing bracket (B) after removing the installation bolt (A).
Remove the fuel line fixing bracket (B) after removing the installation nut (A).
Open the fuel line fixing clip (A) with the (-) driver.
Remove the fuel line under the vehicle. Be careful not to damage the fuel line.
Installation is reverse of removal.
Must be free from extream deformation, twist, bending and interference with other parts.
Fuel line (Especially connection area) must not be leaked when starting the engine.
After removing or replacing the part below, bleed air in low pressure fuel circuit.
(Refer to Fuel Delivery System - "Bleeding Air in Low Pressure Fuel Circuit")
Fuel Tank
Fuel Sender
Fuel Filter
High Pressure Fuel Pump
Low Pressure Fuel Lines
