2.
Disconnect the accelerator pedal position sensor connector (A).
Turn ignition switch OFF.
Disconnect the accelerator position sensor connector.
Measure resistance between voltage supply terminal and ground terminal of APS1.
Measure resistance between voltage supply terminal and ground terminal of APS2.
Check that the resistance is within the specification.
Specification: Refer to Specification section.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the accelerator pedal position sensor connector (A).
Remove the accelerator pedal assembly from the vehicle after unscrewing the mounting bolt (B) and nuts (C).
Installation is reverse of removal.
Accelerator pedal installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
