3.
Disconnect the crankshaft position sensor connector (A).
Check signal waveform of CMPS and CKPS using a scan tool.
Specification: Refer to "Signal Waveform"
Turn the ignition switch OFF and disconnect the battery (-) cable.
Remove the intake hose.
<a href="content.asp?vehicletype=Passenger&mfrcode=KM&area=KME&langcode=ENG&modelid=JD12&modelyr=2013&mmctype=en&mmcid=349&group=SHOP&pdftype=&cat1=2013+%3E+D+1%2E4+TCI%2DU2&ec=&firstnodedesc=Engine+Mechanical+System&sitinfolist=12%5E1235%5E12350100%5Enone%5E801%5E1%5EENG%5EKM%5EJD12%5E2013%5Een%5E348%5Enone%5Enone%5Enone%5ESHOP%5E%24" target="_blank">(Refer to Engine Mechanical System - "Air Cleaner")</a>
Disconnect the crankshaft position sensor connector (A).
Remove the crankshaft position sensor (A) after removing the installation bolt.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
When you install the dust cover, stick it to the block. And then must check the sensor cable whether seperating.
Installation is reverse of removal.
Crank shaft position sensor installation bolt:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
