4.
Remove the WGT control solenoid valve (D) after removing the bolt (B).
Turn ignition switch OFF.
Disconnect the WGT control solenoid valve connector.
Measure resistance between terminal 1 and 2 of the valve.
Check that the resistance is within the specification.
Specification: Refer to Specification section.
Turn ignition switch OFF.
Disconnect the WGT control solenoid valve connector (A).
Disconnect the hoses (C) after removing the bolt (B).
Remove the WGT control solenoid valve (D) after removing the bolt (B).
Install is reverse of removal.
