3.
Disconnect the low pressure fuel quick-connector (A).
Turn the ignition switch OFF, and then remove battery (-) cable.
Release the residual pressure in fuel line.
(Reter to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
Disconnect the low pressure fuel quick-connector (A).
Disconnect the vapor hose (A) which is connected from the PCSV.
Disconnect the fuel feed quick-connector (A) freom the fuel pump.
Lift the vehicle.
Disconnect the vapor tube quick-connector (A).
Open the vapor tube line fixing clip (A) to using driver.
Open the fuel feed line fixing clip (A) to using driver.
Disconnect the fuel & brake line protect (A) from the fixing clip.
Disconnect the fuel feed line fixing clip (A) from engine room lower.
Remove the fuel line (A).
Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Installation is reverse of removal.
