Set the front tires straight-ahead before assembling the steering wheel.
If the steering wheel and the front tires are not set straight ahead together, it affects the number of revolutions of steering wheel and the cable inside the clock spring is possible to be damaged.
Disconnect the battery negative cable.
After disconnecting the battery negative cable, wait for at least thirty seconds.
Set the clock spring in center before assembling it to a steering wheel.
Center pin(A) is locked to a clock spring and it is set in center.
Center pin(A) should be removed after the clock spring is assembled with a steering wheel.
Center pin(A) should not be removed until complete assembling of the clock spring.
If the center pin is already removed, set the clock spring in center with the following procedure.
Turn the clock spring clockwise to the stop
2 revolutions counterclockwise.
Check the orange indicater in the clock spring.
Connect the clock spring harness connector and horn harness connector to the clock spring.
Install the steering wheel column cover and the steering wheel. (Refer to the Steering System group- Steering Column and Shaft)
Connect the Driver Airbag (DAB) module connector, and then install the Driver Airbag (DAB) module on the steering wheel.
Connect the battery negative cable.
After installing the airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Make sure horn works.
Set the front tires straight-ahead before assembling the steering wheel.
If the steering wheel and the front tires are not set straight ahead together, it affects the number of revolutions of steering wheel and the cable inside the clock spring is possible to be damaged.
Disconnect the battery negative cable.
After disconnecting the battery negative cable, wait for at least thirty seconds.
Set the clock spring in center before assembling it to a steering wheel.
Center pin(A) is locked to a clock spring and it is set in center.
Center pin(A) should be removed after the clock spring is assembled with a steering wheel.
Center pin(A) should not be removed until complete assembling of the clock spring.
If the center pin is already removed, set the clock spring in center with the following procedure.
Turn the clock spring clockwise to the stop
2 revolutions counterclockwise.
Make sure to set an array the mark (▶◀).
Connect the clock spring harness connector and horn harness connector to the clock spring.
Install the steering wheel column cover and the steering wheel. (Refer to the Steering System group- Steering Column and Shaft)
Connect the Driver Airbag (DAB) module connector, and then install the Driver Airbag (DAB) module on the steering wheel.
Connect the battery negative cable.
After installing the airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Make sure horn works.
