3.
Disconnect the low pressure fuel quick-connector (A).
Turn the ignition switch OFF, and then remove battery (-) cable.
Release the residual pressure in fuel line.
(Reter to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
Disconnect the low pressure fuel quick-connector (A).
Disconnect the vapor hose (A) which is connected from the PCSV.
Disconnect the fuel pump connector (A) and fuel feed quick-connector (B) from the fuel pump.
Disconnect the vapor tube quick-connector (C).
Remove the fuel tank.
(Refer to Fuel Delivery System - "Fuel Tank")
Remove the fuel tube clamp mounting bolt (A).
Remove the fixing clips (A).
Remove the brake & fuel line protect.
Remove the fixing clips.
Remove the fuel line (A).
Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
