3.
Separate the control cable from the control shaft after remove the pin (A) and washer (B).
Remove the following items;
Engine cover
(Refer to Engine Mechanical System - "Engine Cover")
Air cleaner assembly
(Refer to Engine Mechanical System - "Air Cleaner")
Battery and battery tray
(Refer to Engine Electrical System - "Battery")
Set shift lever to N position.
Separate the control cable from the control shaft after remove the pin (A) and washer (B).
Remove the control shaft assembly after loosen the bolts.
Tightening torque:
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m,14.5 ~ 19.5 lb-ft)
Install in the reverse order of removal.
When installing, set control shaft lever to neutral position.
When installing, apply the sealant as shown in the illustration.
Specified sealant : MS 721-40 or MS721-38
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
