Component Inspection
■ Injector Resistance Inspection
1.

Ignition "OFF"

2.

Disconnect Battery (-) terminal.

3.

Refer to "Shop Manual" and disconnect Injector connector.

4.

Measure the resistance between Pin No. 1 (Control) terminal and Pin No. 2 (Power) terminal of Injector.

Specification : Approx. 13.8 - 15.2Ω at 20℃(68℉)

5.

Is measured value within specification?

▶ Go to "System Inspection" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If no problems were found with the circuits or connectors, Replace the Knock Sensor and then go to "Verification of Vehicle Repair" procedure.

caution

- Install the component with the specified torques.

- Note that internal damage may occur when the component is dropped or mis- treated.

Яндекс.Метрика