9039663

1.

Refer to "Shop Manual" and viasullay and/or physically inspect following conditions;

- Damage, cracks, carbon and flashover.

- Poor connection or damaged harness.

2.

Measure the primary coil resistance between terminals (+) and (-). (A)

3.

Measure the secondary coil resistance between terminal (+) and out terminal of secondary ignition coil. (B)

Specification : Refer to Figure below

Resistance	Primary Coil (A)	Secondary Coil (A)
Resistance	0.62 ± 10% (68℉(20℃))	7.0k ± 15% (68℉(20℃))

4.

Has any problems been found?

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace ECM and then go to "Verification of Vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace Ignition Coil and then go to "Verification of Vehicle Repair" procedure.

caution

When replacing the ECM/PCM, the vehicle equipped with the immobilizer must be performed procedure as below.[In the case of installing used ECM/PCM]

1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)

2) After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to "Immobilizer" in BE group)

[In the case of installing new ECM/PCM]

Perform "Key teaching" procedure with GDS. (Refer to "Immobilizer" in BE group)

caution

When replacing the ECM/PCM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.

[In the case of installing used ECM/PCM]

1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Smart key" in BE group)

2) After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM/PCM learns the smart key information automatically.

[In the case of installing new ECM/PCM]

Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM/PCM learns the smart key information automatically.