9040382

1.

Ignition "OFF".

2.

Ignition "ON" & Engine "OFF".

3.

Connect GDS and select "Diagnostic Trouble Codes(DTCs)" mode.

4.

Using a GDS, Clear DTC.

5.

Operate the vehicle within DTC Detecting Condition in General Information. (turn right and left at least 1 time)

6.

Select "Diagnostic Trouble Codes(DTCs)" mode again.

7.

Are any DTCs present?

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace BSD ECU assembly and then go to "Verification of Vechicle Repair" procedure.

▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.