9040747

1.

Ignition switch "OFF"

2.

Disconnect battery (-) cable.

3.

Refer to "Shop Manual" and remove EGTS.

4.

Measure the resistance between Pin No. 1 (Signal) terminal and Pin No. 2 (Ground) terminal of EGTS.

Specification : Refer to table below

※ The resistance value decreases as temperature increases.

Temp.(℃/℉)	100 / 212	300 / 572	600 / 1,112	900 / 1,652
Resistance(kΩ)	289.0 - 481.0	5.30 - 6.61	0.35 - 0.38	0.08 - 0.09

5.

Is the measured value within specification?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If no problems were found with the circuits or connectors, replace the EGTS(T5) and go to "Verification of Vehicle Repair" procedure.

caution

•

When installing component, tighten it within specification.

•

If component is dropped, check for proper operation. The internal damage may be present.