If the output voltage of EGTS #2 is above threshold value for more than 3 sec., ECM sets DTC P247100. This fault might be caused by open in signal circuit of EGTS #2.
Item | Detecting Condition | Possible Cause | |
DTC Strategy |
•
Signal monitoring | 1. Open in signal circuit of EGTS #2 2. Faulty EGTS #2 | |
Enable Condition |
•
Engine running | ||
Threshold Value |
•
Output signal is below threshold value (110℃/230℉) | ||
Detecting Time |
•
3 sec. | ||
Fail Safe | MIL |
•
Blink | |
DPF Regeneration OFF |
•
Yes | ||
