Component Inspection
1.

Ignition "OFF".

2.

Disconnect BSD switch connector.

3.

Measure resistance between Pin No. 13(signal) and Pin No. 16(ground) terminal of BSD switch. (Component Side)

BSD switch

ON

OFF

Specification

Approx. 200 Ω

∞

4.

Is the measured value normal?

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace BSD ECU assembly and then go to "Verification of Vechicle Repair" procedure.

▶ Substitute with a known-good BSD switch and check for proper operation.

If the problem is corrected, replace BSD switch and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика